February 6, 2018 at 7:19 pm #2449simonKeymaster
The aim of this guide is to outline how to go about establishing a habitat monitoring baseline. The guide describes what time of year is best for each habitat, how to establish plots and what other factors to consider. The guide Habitat Impact Assessment: Principles should be regarded as an essential introduction to this subject.
Example forms for recording habitat data can be found in the Reference section.
What to do
Establish the baseline by setting out the marked (‘permanent’) plots. Plots should be marked by wooden posts (approximately 5 x 5 x 20cm) and their location recorded by GPS. Posts or tags should be small enough to minimise their attention by deer; hammered below vegetation height, or located at a fixed distance (e.g. 10m) from the plot.
- The impact assessment itself should be done at the time of year indicated in the table. Outwith this period plants are less easy to identify and impacts less easy to measure.
When establishing plots:
- Be aware of ground nesting birds. Avoid placing plots where birds are showing alarm behaviour. Avoid any disturbance of ground nesting birds during wet or windy conditions.
• Minimise trampling. Try not to cause more impact than what you are measuring!
• If conducting impact assessment on designated sites consult SNH.
Identifying plants and impacts
The BPGs on habitat impact assessment illustrate the key plant species and impacts required in each guide. It is recommended that additional plant field guides are used to help in species identification. Similarly, for impacts the SNH field guide(footnote 2) provides a more detailed description of assessing current and historic impacts e.g. “normal, carpet, topiary and drumstick” growth forms of heather.
Is it deer?
Other herbivores may also be present and causing impacts – insects, birds, sheep, hares, rabbits and goats*. Three things can help determine which animals are likely to be having the biggest effect:
- Presence of dung (notice difficulties in separating sheep dung from deer dung);
- Browsing signs on plants measured;
- Relative numbers from counts etc.
Is it damage?
Deer are herbivores, herbivores eat vegetation, therefore deer will always have an impact on their habitat. The BPGs describe how to measure grazing and trampling impacts by deer. Assessing the measured impacts against the objectives (private or public) for the habitat area will determine whether the impacts are ‘damaging’**. The effect of continuing the current impacts on the habitat also need to be considered – are they sustainable or will they lead to damage or deterioration?
Impacts are also likely to be interpreted as ‘damage’ if:
- Unpalatable plants (i.e. which deer do not normally eat) are being browsed;
- Heavy or high impacts are widely found.
How to analyse
Initially impacts measured will form a baseline. Subsequent monitoring in relation to objectives will determine whether impacts are sustainable or potentially damaging.***
- You must be logged in to reply to this topic.